How to correctly replace or install a new bathtub

bathtub

Installing a bathtub is a hard task that, in most cases, cannot be done by an amateur. It, therefore advisable that you get a professional to do the job on your behalf. Perhaps the most challenging bit of installing a bathtub is constructing the plumbing system. The plumbing system allows for water to get in and out of the tub. Other elements of the plumbing system include connecting the water source to the heater for hot water. In case you have had your plumbing system put in place by a professional, it may be easier to install the tub itself. In this article, bathtubs Sydney provides you insight on how to install or replace a bathtub in your bathroom.

The process of installing a bathtub

  • The first step to fixing a tub or replacing an old one for a new one is to turn off the main water line. You have first to locate the mainline and make sure that it is turned off all the way. Having done that, make sure that your tub is drained completely.
  •  In case it is a replacement job, the next step would be to remove the old tub. While removing the bath, you have to make sure that you also remove the tiles or drywall surrounding the tub. The point of this is to gain access to the plumbing system that usually is beneath the bathtub. In most cases, you may need to cut a hole through the wall or the floor to get to the plumbing line.
bathtub
  • Once the old tub is removed, the next step would be to take measurements of the area. The measures will help you determine the right size of the tub to install. You can either choose to install a bathtub with the same measurements as the old one or a larger one.
  • When deciding on the replacement bathtub, you have to make sure that all the necessary accessories accompany it. Some of these accessories include faucets, water handles, and drains. There are different drains to choose from as well as drain covers.
  • Once you have the tub of your choice, place it in the area you want in installed to ensure that it fits. The drain hole located at the bottom of the tub needs to directly line up with the P-tap on the floor or the wall underneath the tub. Connect the faucets to the water supply lines using the right tools.
  • The next step on the list would be to install the cement or the tiles or any other surround material of your choice to hold the bathtubs in place. Once this is done, attach the water drain to the tub. Connecting the overflow to the main pipe would also come in handy at this point.

Bottom Line

The process of setting the bathtub in place and securing it as well as the surround is exact. There are specific tools for use and a step by step procedure to follow. It is, therefore, a wise decision to get a guide or an instruction manual to help during the process.

Leave a Reply

Your email address will not be published. Required fields are marked *